Hallo together,
how can i see if have generated a block without waiting 120 blocks ?
Until now i just know it that its stand somewhere in the debug.log
Cheers
Yadric
How can i see if i have generated a block
Re: How can i see if i have generated a block
From where your namecoind executable is, enter (in a terminal):
namecoind listtransactions
that will show the state of your transactions
namecoind getinfo
or
namecoind getbalance
these will show the state of your wallet
namecoind listtransactions
that will show the state of your transactions
namecoind getinfo
or
namecoind getbalance
these will show the state of your wallet
Re: How can i see if i have generated a block
Hi,
i know. But i read elsewhere that you can only see a transaction or a "amount" after 120Blocks.
I'm confused a bit at the moment.
Cause i am running a rig with 1,6GHashs
The calculator says estimated time: 11hours xx mins
The rig is running now for 18h+ and still no notifications about transfers.
-------
Is their a way to check it over the debug.log?
Cause i can only see XXX Mhash per sec on my phoenix shells all the time and nothing more.
Dont know if its working correctly.
best regards
i know. But i read elsewhere that you can only see a transaction or a "amount" after 120Blocks.
I'm confused a bit at the moment.
Cause i am running a rig with 1,6GHashs
The calculator says estimated time: 11hours xx mins
The rig is running now for 18h+ and still no notifications about transfers.
-------
Is their a way to check it over the debug.log?
Cause i can only see XXX Mhash per sec on my phoenix shells all the time and nothing more.
Dont know if its working correctly.
best regards
Re: How can i see if i have generated a block
Hi, i have a question(solo mining) , if i stop mining or close the namecoind.exe before finding a block , all my work goes to waste? if i reebot i have to start all over again ? I hope not .
Thanks
Thanks
Re: How can i see if i have generated a block
Yes, you do - nothing is persistent when it comes to mining unless you're working as part of a pool, and even then any accepted work would be lost if the namecoin daemon goes down.
Re: How can i see if i have generated a block
No. There is no progress or smth else, if you stop your mining, you just stop your current round.Skinenr wrote:Hi, i have a question(solo mining) , if i stop mining or close the namecoind.exe before finding a block , all my work goes to waste? if i reebot i have to start all over again ? I hope not .
Thanks